Brands for Central Vac Inlets, Elbows, etc.

This Inlet Extension is designed for use with their inlet valves when mounting in walls which are thicker than they are designed to handle. It extends the tube on the back of the inlet so it seals properly in the mounting plate's hole.   Show Less

This white Central Vac 45° Double Wye is designed to couple two branch pipes on a 45° angle into a main line. Two 45° Spigots #765518W are sometimes used with this wye to couple two in-line branches with a main pipe at a 90° angle.

This wye should not be confused with the 45° Wye #752046 which is not symmetrical like this one is. All three openings are female to mate with the standard "Schedule L" thin wall PVC pipe.   Show Less

This Inlet Mounting Plate is designed for mounting their standard inlet in a 2 x 3 wall with drywall or plaster. This plate is not needed for the Hayden SuperValve since their unique mounting plate is packaged with the inlet.

Due to the limited space, a special Short 90° Spigot #765506W is typically used directly behind the mounting plate. All other elbows, tees, etc. should be the sweep type so any object which is able to get through the short elbow should also pass through the others easily.   Show Less

This white Hayden Exhaust Vent Cap mounts on the outside of your house where the central vacuum exhausts the air. It has a 2 1/2" square flap which blows open when the vacuum runs and closes automatically when not running. Two screw holes on 3 5/8" centers enable you to secure it to the wall.

The dimentions of the faceplate are 3 5/8" wide and 4 5/8" high. If has a female opening on its back which mates with the standard "Schedule L" thin wall PVC pipe.   Show Less