Brands for Central Vac Inlets, Elbows, etc.

This white Central Vac 45° Double Wye is designed to couple two branch pipes on a 45° angle into a main line. Two 45° Spigots #765518W are sometimes used with this wye to couple two in-line branches with a main pipe at a 90° angle.

This wye should not be confused with the 45° Wye #752046 which is not symmetrical like this one is. All three openings are female to mate with the standard "Schedule L" thin wall PVC pipe.   Show Less

This white Central 45° Short Spogot is designed to couple a pipe and an elbow or wye together where that angle is needed. Two of these are often used with a 45° Double Wye #752145 where two in-line branches join with a main pipe line at a 90° angle.

If a line were drawn through the center of the curve, it would form a 45° arc with a 1" radius. One opening is female to mate with the standard "Schedule L" thin wall PVC pipe while the other is male to mate with an elbow, tee, wye, etc.   Show Less

This white Central 90° Short Spigot is designed to be used only at the back of the 2x3 Inlet Mounting Plates #791044W due to the very limited space in a 2x3 wall.

One opening is female to mate with the back of the mounting plate while the other is male to fit inside of the standard "Schedule L" thin wall PVC pipe.   Show Less

This white 90° Sweep Spigot is designed to couple a pipe and an elbow in a central vacuum pipe system. This spigot & elbow combination is handy where there is an offset between two pipes at a corner and space is limited.

If a line were drawn through the center of the curve, it would form a 90° arc with a 2.5" radius. One opening is male to mate with the standard "Schedule L" thin wall PVC pipe. The other opening is female to mate with an elbow, tee, etc.   Show Less